The "reset high speed USB device using ehci_hcd" error message in Linux typically indicates that there is a problem with the USB device or its connection to the system. This error can be caused by various factors, such as a malfunctioning USB device, a damaged USB port, or a driver issue.
Here are some steps you can try to troubleshoot and fix this error:
Check the USB device and make sure it is functioning properly. If the device is malfunctioning, try using a different device to see if the problem persists.
Check the USB port and make sure it is not damaged. If the port is damaged, try using a different port to see if the problem persists.
Check the USB driver and make sure it is up to date. If the driver is outdated or corrupt, try updating or reinstalling it to see if the problem persists.
If you are using a USB hub, try connecting the device directly to the system to see if the problem persists.
Try restarting the system to see if the error persists.
By following these steps and reviewing the documentation, you should be able to troubleshoot and fix the "reset high speed USB device using ehci_hcd" error in Linux.